All Categories >

Product

+
  • a6d86169-99f9-466a-b42a-9fc53052b198.png

N-BK7 diffuse reflector with a protective gold coating

Diffuse reflectors are a solution for applications that require a specific scattering intensity distribution. The frosted side of the diffuse reflector is coated with a protective gold film.

Classification:

Detail

Parameters

Technical Data

Characteristics

  • Ø1-inch diffuse reflector
  • The coated surface is available in several grits, including 120, 220, 600, or 1500.
  • High-reflectivity gold films with a protective layer are used over a wavelength range from 800 nm to 20 μm.
  • It exhibits an approximately Gaussian intensity distribution at small angles of incidence (AOI).
  • Clear Aperture: >90% of diameter

Diffuse reflectors are a solution for applications that have specific requirements regarding the scattering intensity distribution. The diffuse reflectors featured on this page have a layer on their frosted side. Gold film with a protective layer Unlike transmission diffusers, these diffuse reflectors are less susceptible to absorption losses, enabling them to achieve an average reflectance exceeding 96% across a wavelength range from 800 nm to 20 µm. For alternative coating options, please refer to the Diffuse Reflectors Selection Guide in Table 1.1. These diffuse reflectors are fabricated from N‑BK7 glass, with coated surfaces available in several polishing grades—120, 220, 600, or 1500 grit.

Compared with standard sandblasted diffusers, polished diffusers exhibit superior surface uniformity, offering significant advantages. Polished diffusers are available in a range of mesh sizes, enabling tailored reflectance intensity distributions. Coarser mesh sizes (e.g., 120 mesh) produce broader scattering patterns, while finer mesh sizes (e.g., 1500 mesh) yield more concentrated scattering. The intensity distribution of reflected light (at an angle of incidence of 0°) for each diffuse reflector is shown.

These diffusive reflectors have a thickness of 2.0 mm, which is too thin for our standard mirror mounts and cannot be mounted directly. However, they can be mounted onto our mounts designed for Ø1-inch optical components. LMR1 Fixed mounting bracket, Ø1-inch lens sleeve or KM100T In a threaded adjustment mount, when mounting a diffuser onto a threaded optical component holder (such as the LMR1), the frosted and coated surfaces should face the holder’s lip, and the retaining ring should be secured on the uncoated side. If the diffuser is installed in the reverse orientation, the reflective surface will be recessed within the holder, causing the holder’s housing to block part of the diffused light.

N-BK7 diffuse reflector with a protective gold coating

Other Products

I want to consult

Submission