All Categories >

Product

+
  • 宽带消偏振立方体分束器.jpg

Broadband depolarizing cube beam splitter

Our broadband depolarizing hybrid cube beam splitter is ideal for use with multiple lasers or tunable sources. The transmitted and reflected portions of the incident beam will each be 45%, with the s-polarized and p-polarized components matched to within 10%.

Classification:

Detail

Parameters

Technical Data

Even the power splitting ratio is insensitive to polarization

Broadband and neutralizing chromaticity

Flat spectral response over a wide range of angles of incidence

metal-dielectric hybrid coating

Features

metal-dielectric hybrid coating

Three metal-dielectric hybrid broadband coatings covering the 400 - 700 nm (shown in the figure above), 700 - 1100 nm, and 1100 - 1600 nm wavelength ranges are provided. The transmission and reflection of the incident beam are both 45%, and the matching of the s-polarization and p-polarization components is within 10%. The hybrid beam splitter is less sensitive to changes in the angle of incidence, resulting in being optically color neutral for both converging and diverging beams.

Use with tunable lasers

The broadband depolarization mixing prism beam splitter has moderate absorption ability, but the polarization sensitivity is low. These beam splitters have broad spectral flatness, making them ideal for use with multiple light sources or tunable lasers.

constructed with a pair of right angle prisms

These beam splitters consist of a pair of precise right-angle prisms that are carefully glued together to minimize wavefront distortion. The hypotenuse of one of the prisms is coated with a metal-dielectric hybrid beam-splitting coating optimized over a broad wavelength range. All four sides are coated with a broadband multilayer dielectric coating as an antireflective coating to minimize surface reflection losses over the entire wavelength range. Due to the metallic nature of the hybrid coating, these beam splitters cannot be used for higher power lasers.

appropriate direction

A prism beam splitter is formed by gluing two right-angle prisms together. The hypotenuse of one of the prisms is coated with a partially reflective metal-dielectric coating. In the Newport prism beam splitter, the coated prism has a clearly visible point as a mark. Incident light should enter the prism through the hypotenuse with the coating to minimize power loss through the optical cement. A beam entering through an uncoated prism would otherwise produce more than three times the fluence in the cement (transmission component plus double pass of the reflection component). Higher power beams may cause cement degradation

宽带消偏振立方体分束器

 

宽带消偏振立方体分束器

宽带消偏振立方体分束器

Broadband depolarizing cube beam splitter

Other Products

I want to consult

Submission