Product
Feed-through BNC terminal
Classification:
Detail
Parameters
Technical Data
Two types of feedthrough (coaxial) connectors are available: PJ-084 variable resistance terminals and PJ-085 fixed 50Ω terminals.
Variable Resistor BNC Terminal
The variable resistor termination allows the user to select from eight discrete resistance values in the range of 50 Ω to 100 kΩ (see the table to the right). Rotate the tuning knob inside the housing to change the resistance value until the desired value appears on the window on the front of the housing. There are two tuning points on opposite sides of the housing to operate the resistive tuning knob. Please note that when the resistance is greater than 50Ω, the bandwidth will decrease due to back reflection; continue to increase the resistance value, due to the longer connection line, the bandwidth will be further reduced.
The variable resistance termination is ideal for use with our biased photodetectors. For these photodetectors, a resistance of 50 Ω can make the response time the longest, but it will produce low voltage in many coupling applications. VT2 can be switched to a higher resistance (thereby obtaining a higher voltage) when adjusting the system, and then reduced to a lower resistance to obtain the longest response time.
Fixed resistance BNC terminal
The PJ-085 is a 50 Ω feed-through terminal, and the maximum signal bandwidth can be observed through our bias detectors. It can also attenuate signals with an input power of 2 W (average at 25°C) and a maximum frequency of 500 MHz.


Previous
Previous
Other Products
I want to consult