All Categories >

Product

+
  • 放大器.png

PVA560 Low-Noise Preamplifier

The PVA560 is a high-performance, low-noise voltage preamplifier designed to amplify weak low-frequency signals, with configurable bandwidth and gain.

Classification:

Detail

Parameters

Technical Data

PVA560 It is a high-performance, low-noise voltage preamplifier. It is used to amplify weak low-frequency signals and can be configured with different bandwidths and gains. Applicable to: low-temperature measurements, low-frequency noise measurements of chips, and sensors. Wide-ranging applications, including sensing, photoelectric detection, and audio and vibration engineering. The instrument can be used standalone or in combination with: an oscilloscope, a lock-in amplifier, Comprehensive use of instruments such as dynamic signal analyzers.
Input
PVA560 It features a true differential input configuration, with an input noise spectral density of 3 nV/ √ Hertz ( 50 (Ohm short-circuit), the input impedance is 100 MΩ 。 PA560 The input is fully floating ( BNC Shielding not connected to the chassis Ground). Input offset voltage can be nulled using the front-panel potentiometer, It can be operated with a small screwdriver.
Output
Two isolated outputs BNC Connector, provides 600Ω or 50Ω Loss Output impedance. Both can deliver maximum output. 10 Vpp the signal, in order to Drive the loads of their respective downstream stages.
Filter
PVA560 Includes two programmable first-order stages. RC Filter, by not The same combination can implement five filter mode settings: LPF(6dB/oct) 、 BPF (6 dB/oct) 、 HPF(6dB/oct) 、 LPF(12dB/oct) 、 PF(12dB/oct)) , can be accessed via the front panel Set the filter mode and cutoff frequency. The frequency range spans from 0.03 Hertz to 1 MHz , according to 1-3 Sequence step increment (e.g.: 3Hz , 10Hz , 30Hz , 100Hz… ).
Gain
Gain can be 1-2-5 Set in the sequence, starting from 1 to 50,000 Select within the range. Two gain modes are available, with low noise. The mode filter is preceded by gain allocation to optimize noise performance. Yes, and the high‑reserve mode allocates gain after the filter. Benefit: to reduce sensitivity to signal overload.
Battery operation
Except for 220V In mains‑power mode, the instrument also features a built-in battery for… Electricity. Battery mode can significantly reduce power-frequency interference and conducted emissions. It addresses interference and wireless coupling, while being convenient for field applications. Rechargeable lithium batteries provide up to 10 An hour of continuation Flight. Automatically charges when connected to an external power source; charging time is 4 small At that time, the front panel LED Indicates the battery’s charge status.

PVA560 Low-Noise Preamplifier

Other Products

I want to consult

Submission