31
2024
-
07
Huazhong University of Science and Technology developed a new single-chip 5-centimeter super-lens mid-infrared thermal imager.
Author:
Mid-infrared cameras not only provide night vision, but also provide valuable information about various physical characteristics of the scene (such as temperature distribution and material composition), which is often difficult to obtain using other imaging technologies.
However, the widespread application of existing mid-infrared thermal imagers is subject to some limitations of traditional mid-infrared lenses. First of all, the detection performance of the infrared system mainly depends on the ratio of the lens aperture to the imaging distance. Without reducing the detection performance, the long-distance imaging requires a larger lens aperture. However, traditional mid-infrared lenses are usually designed based on the principles of refraction and reflection and require macroscopic curved surfaces. Therefore, when the lens aperture increases by Δ times, its weight and volume also increases by Δ3 times, resulting in a contradiction between the weight and volume of the mid-infrared thermal imager and the imaging distance. Secondly, the complex lens temperature distribution in the traditional multi-piece lens group will significantly reduce the environmental adaptability of the infrared thermal imager, which requires a complex and not robust calibration model. Third, when measuring the infrared spectral illumination, the added filter will increase the thermal imager loss and reduce the image contrast.
According to Maims Consulting, recently, the research team of Professor Yi Fei of Huazhong University of Science and Technology and Hubei Optics Valley Laboratory used only a single plane lens to achieve uncooled quantitative infrared imaging for the first time. The main results were published in top academic journals on the topic of "Single 5-Centimeter-Aperture Metalens Enabled Intelligent Lightweight Mid-infrared Thermographic Camera (Single 5cm Aperture Superlens Realizing Intelligent Lightweight Mid-infrared Thermal Imager)"Science Advances(Science sub-issue) on. The first author of the paper is Hou Mingming.
Uncooled quantitative infrared imaging using only a single planar lens for the first time
The research team innovatively proposed and developed an ultra-light uncooled thermal imager using only a single planar lens by introducing the "large aperture superlens" into the mid-infrared imaging system. As shown in Figure 1a, the diameter of the superstructured lens used is 5cm, which is one of the largest diameters reported so far. Its thickness is only 0.5mm and its weight is only 3.7 grams, which realizes the miniaturization and light weight of the imaging system., And bring the following benefits. First of all, due to the unique working principle of the superstructure lens, when expanding its imaging distance, it only needs to increase its plane aperture without significantly increasing its weight and volume. This enables the thermal imager to image scenes at different distances in a light architecture, including detailed mapping of near-target infrared emissions (as shown in Figure 1b) and detection of long-distance infrared absorption of harmful gases (as shown in Figure 1c). Secondly, the single-chip planar structure of the superstructure lens simplifies the thermal imager and makes the calibration model more robust, thus enhancing its environmental adaptability and achieving high-precision temperature measurement imaging without refrigeration (as shown in Figure 1d). Third, the spectrally filtered superstructure lens simultaneously improves the image resolution and signal contrast of infrared absorption, enabling the intelligent algorithm to achieve quantitative imaging of unrefrigerated gases for the first time at a hardware cost of small weight, small size and small power consumption (Figure 1e).

Fig.1 Concept and application of thermal imager based on superstructure lens (source: Sci. Adv. eado4847)
Manufacture of Large Aperture and Realization of Long-distance Imaging
In the manufacture of large-aperture superstructure lenses, in view of the limited exposure field of the existing mainstream lithography machine, the research team innovatively uses multi-mask joint step lithography technology to define the layout of the 5-centimeter superstructure lens. Each mask contains a portion of the superlens pattern, and the entire pattern is produced by sequentially exposing nine masks to ultraviolet light. This stitching process is parallel to the stepping of each mask exposure to generate multiple superstructure lens patterns at a time. This method of fabrication allows the creation of a large-area free-phase superstructure lens with an asymmetric, aperiodic pattern. The research team also elaborated on the good tolerance of the method to manufacturing errors in the supplementary materials of the paper. Using this method, the research team successfully fabricated four all-silicon superstructure lenses on 6-inch (15.24cm) silicon wafers with a diameter of 5cm and a thickness of 0.5mm (as shown in Figures 2a-2e). At the center wavelength (λ = 10.6 μm), the fabricated superstructure lens achieves better resolution than conventional lenses with a phase error of <0.4 λ. This technique can be extended to the manufacture of larger aperture superstructure lenses.

Fig. 2 5cm aperture superstructure lens and its application in long-distance thermal imaging (source: Sci. Adv. eado4847)
As shown in Figure 2f, the large-aperture superstructure lens is beneficial to long-distance imaging by improving the resolution (resolving power) of the infrared system. To further quantify the resolution as a function of the aperture D, the pixel density C is defined as the "effective resolution" of the target unit critical dimension, which is proportional to the probability of detecting the target (see the paper supplement for details). Figure 2g shows that under the same F number, the C of the large-aperture superstructure lens (D = 50mm) manufactured by the research team is significantly higher than that of the small-aperture superstructure lens (D = 5mm). At greater distances, the difference in C between the large-aperture superstructure lens and the small-aperture superstructure lens translates into a qualitative difference in target recognition ability. For example, as shown in Figure 2g, when L = 18 meters, the large-aperture superstructure lens has a stronger ability to recognize people (C = 159 m¹¹> CR = 80 m≡¹), while the small-aperture superstructure lens has a stronger ability to recognize people. Poor (C = 15.9 m≡¹
The research team carefully characterized the stray light introduced by the superstructure lens. In view of the stray light problem, the research team innovatively adopted deconvolution processing to remove the stray light and improve the image quality, realizing thermal imaging at a distance of tens of meters. The result of deconvolution is shown in FIG. 3c, which verifies that the image contrast is improved and the spatial crosstalk of signals between pixels is reduced. This enables the superlens to extract the correct infrared signal in high dynamic range scenes, enabling applications such as high-precision temperature mapping. It is worth noting that this method provides an important solution to the stray light problem of flat lenses, which has not been reported in previous studies. Since it is still very challenging to eliminate the stray light of large aperture planar lenses by improving the broadband diffraction efficiency, the research team's method of eliminating stray light by calculation shows a clear advantage. Figure 3d shows the measured results of indoor imaging at a distance of several meters. When the imaging distance is greater than 5 meters, the image quality of the heated target captured by the developed large aperture superstructure lens camera is significantly higher than that of the 7mm aperture commercial infrared camera.

Fig.3 Partial imaging performance of 5cm aperture superstructure lens in long-wave infrared (8 ~ 12μm) (source: Sci. Adv. eado4847)
Realizing Temperature Measurement and Gas Imaging with Smart Calibration and Intelligent Algorithm
The team demonstrated two typical applications for the camera: temperature measurement and gas imaging.
For temperature measurement, in order to eliminate the influence of environmental interference and unstable working conditions of unrefrigerated detectors, the research team has established an exquisite temperature measurement calibration model, as shown in Figures 4a and 4b. Thanks to the introduction of superlens, the thermal imager has achieved temperature measurement with an accuracy better than ± 0.7 for blackbodies in the range of 35 to 700 degrees Celsius and adapted to ambient temperature fluctuations of 1.98 degrees Celsius. Figures 4c, 4d and 4e are the temperature measurement imaging results of the electric soldering iron (gray body). The stray light removal algorithm reduces the measurement error from -8.7-66.5 K to -3.3-5.4 K. The camera can also be used for dynamic visualization of thermophysical phenomena (Figure 4f).

4 Main results of thermometry (source: Sci. Adv. eado4847)
For gas imaging, intelligent algorithms and filtering technology are used to visualize and quantify sulfur hexafluoride gas leakage at a distance of 5 meters, and the minimum detectable leak rate is only 0.2 sccm. Thanks to the improved image resolution and signal contrast of the thermal imager, the details of the air plume can be resolved (Figure 5g, Figure 5h, and Figure 5i), thereby further estimating the gas leakage rate (Figure 5j and Figure 5k).

5 Main results of gas imaging (source: Sci. Adv. eado4847)
The research team prepared detailed supplementary materials for the paper (as shown in Figure 6), from the aperture wavelength, manufacturing, technical principles and other aspects of the current development of the plane lens in detail, in theory in-depth study of the aperture for infrared superstructure lens, but also detailed the technical details of the paper.

Figure 6 Catalogue of supplementary materials for papers (source: Sci. Adv. eado4847)
Summary and Prospect
1. The thermal imager developed by the research team has both a large imaging aperture and a small volume, weight, and power consumption (SWaP), which effectively solves the traditional thermal imaging camera in the imaging distance and volume, weight, and power consumption (SWaP). The trade-off problem between paving the way for the development of small SWaP systems;
2. Further reduction of chromatic aberration of superstructure lenses, such as optimization for end-application requirements (e. g. end-to-end optimization), will enhance the applicability of large-aperture superstructure lenses in high-performance scenarios (e. g. cancer diagnosis) (see paper supplement);
3. Large aperture superstructure lens opens the way for multi-functional intelligent infrared thermal imager, which has advanced imaging modes, such as spectral imaging, polarization imaging and so on. For example, since the superlens can be configured as a multispectral lens or an imaging grating, gas temperature measurement and simultaneous detection of multiple gases can be achieved.
This technology has a wide range of applications in surveillance, reconnaissance, navigation, medical diagnosis, building inspection, and hazardous gas leak detection and imaging.
At present, the above research results have been granted a Chinese invention patent (a large-aperture infrared superlens camera, patent number 2021112394165) and a U.S. patent (Large-aperture Infrared Metalens Camera, patent number US11815665B2). Related work has been funded and supported by the National Key R & D Program, the National Natural Science Foundation, the Optics Valley Laboratory Innovation Project, the Shenzhen Science and Technology Plan, as well as a pre-project and the Yantai Development Zone Leading Talent Project.
Research Team Profile
The research direction of Professor Yi Fei's research team is micro-nano photonics, infrared detection imaging technology, photonic integrated chip, intelligent photoelectric micro-system, etc. In recent years, around the scientific problem of multi-dimensional information acquisition of light, multi-dimensional detection imaging technology based on superstructure optics has been independently developed, which provides a solution for the problems of single detection dimension, low degree of freedom of component design, large system volume and weight, and complex structure in traditional infrared imaging technology, and opens up a way for the realization of the next generation of lightweight, low power consumption, intelligent multi-dimensional infrared optical system. The work of the research team has been supported by national vertical projects such as the National Natural Science Foundation of China, the National Key Research and Development Program of the Ministry of Science and Technology, and a pre-research project, as well as Hubei Optics Valley Laboratory Key Project, Shenzhen Science and Technology Plan Project, Yantai Development Zone Science and Technology Leading Talent Project and other local science and technology projects. The innovations achieved are published inNature Photonics,Nature Communications,Science Advancesand other authoritative journals, and approved 17 Chinese invention patents, 5 U.S. patents.
Introduction to the First Author
Hou Mingming (contact E-mail: houmm@hust.edu.cn), PhD student, School of Optoelectronics, Huazhong University of Science and Technology. He has presided over the innovation and entrepreneurship fund for graduate students of Huazhong University of Science and Technology, participated in the national key research and development plan, the general project of the National Natural Science Foundation, the pre-research project of a certain department and a number of horizontal projects of leading enterprises. During his Ph.D., he devoted himself to solving the technical bottleneck of planar lens and developing its application in infrared imaging, optical communication, quantum information and other fields. The results of the study were published by the first author inScience AdvancesSuch as international top journals, in the CLEO top meeting to make an oral report, related technology has authorized a U.S. invention patent and a number of Chinese invention patents, won the first prize in central China, the national finals excellence award, to participate in guiding the national college students photoelectric design competition. In the future, we will continue to make academic breakthroughs and technological industrialization in the direction of next-generation infrared optical technology, ultra-light optical instruments, and physical intelligence.
Chongqing Chongfan Technology Co., Ltd. Optical platform film thickness meter OCT optical coherence tomography LabVIEW control